STUDY OF S235 STEEL CORROSION PROCESS IN WASTEWATER FROM THE PETROCHEMICAL INDUSTRY

Authors

  • Julieta Daniela CHELARU Department of Chemical Engineering, Faculty of Chemistry and Chemical Engineering, Babeş-Bolyai University, Cluj-Napoca, Romania. Email: jdchelaru@chem.ubbcluj.ro. https://orcid.org/0000-0001-5861-5073
  • Liana Maria MUREŞAN Department of Chemical Engineering, Faculty of Chemistry and Chemical Engineering, Babeş-Bolyai University, Cluj-Napoca, Romania. Email: limur@chem.ubbcluj.ro. https://orcid.org/0000-0002-2891-2947

DOI:

https://doi.org/10.24193/subbchem.2019.2.27

Keywords:

electrochemical impedance spectroscopy, polarization curves, steel corrosion, corrosion inhibitors, petroleum industry corrosion

Abstract

The aim of this study is to investigate the corrosion behavior of low carbon steel (S235) used in petrochemical industry. The corrosion process was analyzed in simulated wastewater at different values of pH and at different temperatures and also in real wastewater from the exploitation of crude oil from Transylvania, Romania. Two commercial corrosion inhibitors (Nalco 73413 (Nalco Products, USA,) and Galoryl IC20 (ArrMazz Chemicals SAS, USA) were tested at different concentrations. The corrosion behavior was investigated by electrochemical impedance spectroscopy and potentiodynamic polarization measurements. Adsorption of these inhibitors was found to obey Langmuir adsorption isotherm.

References

M.N. Ilman, Kusmono, Case Studies in Engineering Failure Analysis, 2014, 2, 1 - 8.

W. Geary, Case Studies in Engineering Failure Analysis, 2013, 1, 249 - 256.

G. Sıgırcık, T. Tüken, M. Erbil, Applied Surface Science, 2015, 324, 232 - 239.

T. Liu, Y. F. Cheng, M. Sharma, G. Voordouw, Journal of Petroleum Science and Engineering, 2017, 156, 451 - 459.

W Zhao, Y. Zou, K. Matsuda, Corrosion Science, 2015, 51, 761 - 768.

R. Xiao a, G. Xiao, B. Huanga, J. F. Qionghui, Engineering Failure Analysis, 2016, 68, 113 - 121.

Y. Liu, B. Zhang, Y. Zhang, L. Ma, P. Yang, Engineering Failure Analysis, 2016, 60, 307 - 315.

M. Finšgar, J. Jackson, Corrosion Science, 2014, 86, 17 - 41.

M. Askari, M. Aliofkhazraei, S. Ghaffari, A. Hajizadeh, Journal of Natural Gas Science and Engineering, 2018, 58, 92 - 114.

Y. Zhu, M. L. Free, R. Woollam, W. Durnie, Progress in Materials Science, 2017, 90, 159 - 223.

A. A. Olajire, Journal of Molecular Liquids, 2017, 248, 775 - 808.

K. Haruna, I.B. Obot, N.K. Ankahc, A.A. Sorour, T.A. Saleha, Journal of Molecular Liquids, 2018, 264, 515 - 525.

Gh. Golestani, M. Shahidi, D. Ghazanfari, Applied Surface Science 2014, 308, 347 – 362.

J. D. Chelaru, D. Aylakov, L. M. Mureşan, Studia UBB Chemia, 2017, 62(4, Tom II), 357 - 368.

H. Essom, Journal of Materials and Environmental Science, 2015, 6 (7) 1850 – 1857.

Downloads

Published

2019-06-28

How to Cite

CHELARU, J. D. ., & MUREŞAN, L. M. . (2019). STUDY OF S235 STEEL CORROSION PROCESS IN WASTEWATER FROM THE PETROCHEMICAL INDUSTRY. Studia Universitatis Babeș-Bolyai Chemia, 64(2), 323–333. https://doi.org/10.24193/subbchem.2019.2.27

Issue

Section

Articles

Most read articles by the same author(s)

1 2 > >> 

Similar Articles

<< < 4 5 6 7 8 9 10 11 12 13 > >> 

You may also start an advanced similarity search for this article.