Model of microprocessor centrifugal equipment for honey extraction

Eugen RĂDUCA; Mihaela MOLNAR; Nicolae Titu FARA

doi:10.24193/subbeng.2020.1.18

Authors

Eugen RĂDUCA Babeș-Bolyai University, Faculty of Engineering, Piaţa Traian Vuia, nr. 1-4, 320085, Reşiţa, e.raduca@uem.ro https://orcid.org/0000-0002-5489-3647
Mihaela MOLNAR Babeș-Bolyai University, Faculty of Engineering, Piaţa Traian Vuia, nr. 1-4, 320085, Reşiţa, m.molnar@uem.ro (* corresponding author)
Nicolae Titu FARA Eng., TMK Reșița, Str. Lalescu Traian, 36, Resita, fara.nicolaetitu@yahoo.com

DOI:

https://doi.org/10.24193/subbeng.2020.1.18

Keywords:

model, extraction, honey, microprocessor

Abstract

The paper presents a model of centrifugal equipment for extracting honey made around an ATmega 328 processor, with which the Arduino Uno module is equipped. The created model is functional, being tested, and the practical results obtained would allow the transition to prototype equipment. The created model is flexible, allowing to obtain flexible operating cycles, with variable speeds, soft settable, in both directions of rotation. The number of frames from which the bee honey can be extracted is variable depending on the juicer itself, which is driven by the motor.